![]() PING 192.168.0.200 (192.168.0.200): 56 data bytesĦ4 bytes from 192.168.0.200: icmp_seq=0 ttl=255 time=133.614 msĦ4 bytes from 192.168.0.200: icmp_seq=1 ttl=255 time=3.227 msĦ4 bytes from 192.168.0.200: icmp_seq=2 ttl=255 time=4.719 msģ packets transmitted, 3 packets received, 0.0% packet loss After running wireshark, start a capture on your interface connected to the Internet (usually eth0 or something like that), then set a filter (a regular. ![]() OK, something wrong.īut even when I ping the device Wireshark shows nothing at that IP address: MyMachine:~ mnewman$ ping -c 3 192.168.0.200 When I use a filter with the IP address of the device (ip=192.168.0.200), Wireshark detects no traffic at all even when I send a formerly working message via UDP. I've found it to be a steep learning curve. A friend suggested using Wireshark to check network traffic. This was working fine for me for a while and then stopped. You can control the bulb by sending UDP messages at port 55443. I've changed the binding order in Adapter Settings. ![]() Step2: Open command line or terminal in Windows or Linux respectively. I realize that the obvious answer is to let wireshark capture all the time and my problem is solved -), but I would really like to get the NLB working properly. How to get ICMP packet in Wireshark Step1: We can use ping tool to get ICMP request and reply. ![]() It will assist you in capturing network packets and displaying them in detail. I've removed NLB and re-added same behavior. You probably want to analyze the traffic going through your. Wireshark is the most popular and commonly used network protocol analyzer in the world. I'm trying to figure out why the "LAN Control" on a Yeelight "smart lightbulb" stopped working. You will now see a pop-up window on your screen. The method works by sending an ICMP ping packet to the sniffing host with an incorrect destination MAC address.
0 Comments
Leave a Reply. |